V-SERIES: Full Range In Line Oiler

The Difference

V-Series is designed to remove the pitfalls of both “pig” and “injection” oilers. “Pig” oilers reduce line flows by requiring a pressure drop to induce oil, and plugging is all too common.” Injection oilers require many potential fail points (switches, pumps etc.) and do little to operate in concert with air flows. Neither are capable of sizing oil particles for a given air speed, further aggravating hammer lubrication problems. Particles too large to remain in the air stream end up on plumbing walls. Particles too small can pass right through the hammer.

Few operators recognize that a given system will tend to bum out hammers under certain air flow demands, while operating fine under other requirements. Most will suspect the hammer is the problem (including hammer manufacturers themselves). This is the point where oil-to-air ratios in non-proportional oilers (all other brands) is critical. Wasting oil, or burning hammers shuts down your project and increases costs.

The Point

Built-in complexities never add dependability. One failed switch or one plugged orifice and the hammer accumulates damage. V-Series is very simple. It is designed with no moving parts to wear out, stick or fail. To ensure that plugging never occurs, the oil entry into the adjustment valve has 6 ports. This design has never plugged or failed.

The ability to deliver the right amount of oil, at the right size, is paramount to achieve correct lubrication when conditions change. This is key, because if you can’t get it there when it’s needed, it’s too late. When adjusted properly, over oiling and detonation are avoided completely, which is critical in boosted systems.

Design Features

• Fully Proportional delivery (oil/air ratio and oil particle sizing) for infinite feed rates to 10 gallons per hour
• Full 4” fill & sediment ports with air pressure locked plugs, remove easily when line is blown down
• Exclusive “6 port taper inlet” feed valve defies plugging
• Exclusive 30 pound capacity contaminant/water trap
• Perfect delivery on boosted systems to rated working pressures (special order for PSI ranges to 5,000 PSI)
• Internal riser tube automatically relieves unit when system blows down
• Unit shuts down oil feed when air stops moving and automatically begins to feed when air is used
• Rated oil capacity is the full usable capacity (no loss)
• Standard -8 JIC remote drain port for draining
• Tough housing and armored sight glass withstands most impacts and flying rocks
• Reversing air flow direction is quickly accomplished by swapping riser tube and feed line positions
• Unit is easily equipped with additional sight glass for multi-position viewing